CyberPower CP Series Replacement Batteries

CyberPower CP Series Replacement Batteries

Replacement batteries for the CyberPower CP series (CP685 / CP1000 / CP1350 / CP1500 AVR & PFC Sinewave LCD) line-interactive UPS.

CyberPower CP Series Replacement Batteries catalogue

Showing 1-24 of 70

Comparison

Replacing the whole UPS? Refurbished UPS: load-tested, new batteries, 1-year warranty →

Replacement battery cartridges for CyberPower CP Series UPS, the consumer/SOHO line-interactive UPS with PFC sinewave output, AVR, and USB monitoring. Models supported include CP425G, CP485SL, CP500SL, CP550SLG, CP685AVR, CP685AVRG, CP800AVR, CP825LCD, CP825AVRLCD, CP850AVRLCD, CP1000PFCLCD, CP1000AVRLCD, CP1350PFCLCD, CP1500PFCLCD, CP1500AVRLCD, CP1500EPFCLCD plus CP-LCD compact rack and CP-EPS extended runtime variants.

Most CP-series UPS use CyberPower's RB1290X2 (4-cell 12V 9Ah), RB1270X2 (single 12V 7Ah), RB0690X2 (6V 9Ah), or RB1290X4 (8-cell 12V 9Ah) replacement battery codes, always confirm the RB-XXXX code printed on the existing battery cartridge before ordering. CP-PFC models use CyberPower's GreenPower UPS technology (sinewave output) and require matched-spec replacements.

Recommended swap interval: 3-5 years per IEEE 1188. CP cartridges are user-serviceable (slide-out cartridge door at the rear/bottom of the UPS). Need help on multi-unit deployments? Contact our service partner. Calculate runtime before swap.

About CyberPower CP Series Replacement Batteries

Read more: CyberPower CP Series Replacement Batteries

CyberPower CP series replacement batteries

The CyberPower CP series, including the CP685, CP1000, CP1350 and CP1500 AVR and PFC Sinewave LCD models, is a line-interactive UPS range for home offices, workstations and small networks. Its sealed lead-acid (VRLA) battery wears out after about 3 to 5 years; a new battery restores full runtime. Use this page to find the right battery for your exact CP model.

For the full range see CyberPower replacement batteries.

Battery type

CP models use 12 V VRLA batteries, smaller units (e.g. CP685AVR, CP1000AVRLCD) use a single 12 V battery, while higher-capacity units (e.g. CP1500AVRLCD, CP1500PFCLCD) use two 12 V batteries wired to 24 V. Match by your exact model number rather than by VA alone.

How to identify the right battery

Find the model number on the rear or bottom label (e.g. CP1500AVRLCD). Select the matching battery below, or send us your model number and we'll confirm the correct pack.

OEM vs compatible aftermarket

Compatible aftermarket 12 V batteries match the OEM form factor and terminals, with a 1-year UPSPLUSBATTERY warranty.

How long does it last?

3–5 years at 20–25 °C. Heat shortens life: roughly halving it for every ~8 °C above 25 °C. See when to replace a UPS battery.

How to replace

CP batteries are user-replaceable:

  1. Confirm the correct battery for your model.
  2. Power down and unplug the UPS.
  3. Open the battery compartment on the base or rear.
  4. Disconnect the old battery's tabs and remove it.
  5. Fit the new battery (or pair), reconnect observing polarity, and close the compartment.
  6. Recharge and run a self-test.

See how to install a UPS battery.

FAQ

What battery does my CP UPS use?

A single 12 V battery on smaller models, or two 12 V batteries (24 V) on higher-capacity models. Match by exact model number.

OEM or aftermarket?

A compatible 12 V battery matched on voltage, capacity and terminals is the usual choice, with a 1-year warranty.

How often should I replace it?

Every 3–5 years; sooner in warm spaces.

CyberPower® is a registered trademark of Cyber Power Systems. UPSPLUSBATTERY.ca is not affiliated with, endorsed by, or authorized by CyberPower; aftermarket batteries are compatible replacements.

1-year warranty on our replacement batteries
Canadian specialists: 438-881-3363 · Contact us