APC Smart-UPS 2200 Battery Replacements

About APC Smart-UPS 2200 Battery Replacements

APC Smart-UPS 2200 replacement batteries

The APC Smart-UPS 2200 (2200 VA line-interactive) protects servers, networking and other critical loads. Its batteries are a 48 V sealed lead-acid (VRLA) system that wears out after about 3–5 years and then needs replacement to restore full runtime. The exact replacement depends on your specific Smart-UPS 2200 model and generation — confirm yours below before ordering.

For the full APC range see APC replacement batteries and APC Smart-UPS batteries.

Which battery does my Smart-UPS 2200 take?

Amp-hour rating varies by generation, so match by your exact model number rather than VA rating alone. Not sure which you have? The model number is on the rear or side label — send it to us and we'll confirm the correct pack, usually within 1 business day.

How to identify the right battery

Read the model number on the unit's rear or side label (for example SMT2200RM2U or SU2200R3X106). Newer SMT and SMX models take the APCRBC55 cartridge; the legacy SU-series takes a 48 V battery set. APC reuses designs across many SKUs, so your exact model number is the reliable key.

Genuine APC vs compatible aftermarket

Both restore full runtime. Genuine APC: OEM cartridge with a 2-year APC battery warranty. Compatible aftermarket: the same 48 V form factor and connector, built from quality VRLA cells, typically 30–50 % less, with a 1-year UPSPLUSBATTERY warranty.

How long does it last?

3–5 years in a normal 20–25 °C environment. Heat is the main life-shortener — service life roughly halves for every ~8 °C of sustained operation above 25 °C, so a unit in a warm rack or closet may need batteries sooner. See when to replace a UPS battery.

How to replace

Smart-UPS 2200 batteries are hot-swappable — the UPS keeps protecting the load during the swap:

1. Confirm the correct cartridge or set for your exact model.
2. Open the battery compartment (front bezel on tower models; tray latch on rack models).
3. Disconnect the battery connector.
4. Slide the old pack out and the new one in.
5. Reconnect the connector until it clicks.
6. Close up, run a self-test, and allow 8–24 hours for a full charge before relying on full runtime.

See how to install a UPS battery.

FAQ

What battery does the SMT2200 use?

The SMT2200, SMT2200C and SMT3000 (and SMX3000) use the APCRBC55 cartridge — a 48 V VRLA pack. Confirm against your model label.

What about an older SU2200?

Legacy SU2200 models (for example SU2200R3X or SU2200RM3U) take a 48 V replacement battery set. Send us your model number and we'll match it.

Genuine or aftermarket?

For an in-warranty unit, use genuine APC. Out of warranty, a compatible 48 V pack performs identically for 30–50 % less, with a 1-year warranty.

How often should I replace it?

Every 3–5 years; sooner in warm or poorly-ventilated spaces.

APC®, Smart-UPS® and APCRBC™ are registered trademarks of Schneider Electric / APC. UPSPLUSBATTERY.ca is not affiliated with, endorsed by, or authorized by APC by Schneider Electric; aftermarket batteries are compatible replacements.